• 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT
  • 1993 White Ford Bronco for sale in Daniel, UT

Swipe to see 10 photos | View Larger

1993 Ford Bronco XLT

Mileage: 184,000

Daniel, UT | Posted September 3, 2020

$9,900

This Bronco will be finished up this weekend and ready to view. Throwing out a picture early. I am the second owner and have gone through this vehicle thoroughly to make it a great daily driver. The original owner passed and this sat for a couple of years before I took possession of it. It has had new quarters patched in and new paint about 6 years ago. It is presentable but wont be in the Pebble Beach Concours d'Elegance anytime soon. The transmission was replaced at 179k in 2018 with a remanufactured one from AAMCO. Yes I have the paperwork. I also went ahead and replaced the shifter cable and MLPS. Now, here is what has been done to it within the last 100 miles.
For the front end and steering I replaced the upper and lower ball joints, new tie rods and drag link, new sway arm bushings and end links, new steering box and pitman arm, new pro comp ES 9000 quad shocks front and back,new pads, rotors, calipers, and abs sensors. Previous owner did the a-arm bushings. After this was done it went to point•S for the alignment and brake fluid flush. I was informed the rear brake cylinder was leaking so I had them do a complete rear brake job with new drums, shoes, cylinders etc.
The cooling system has been replaced with the following New radiator and cap, new hoses, new heater core, new water pump, new thermostat and housing, and fan clutch. While this was out I went and put in a new timing chain and gears as well as timing cover. While the timing cover was out I put in a new harmonic balancer and oil pressure switch. All hardware was replaced with stainless steel bolts aside from the stud kid. It is new, just not stainless.
I removed the throttle body and installed a new gasket, throttle body positioning sensor and idle air control valve.. The tank was drained of the old gas at pointS, new fuel filter and i went and had them do a fuel pressure check and the pump is doing what it needs to do
I gave it a complete tune up with plugs, cap, rotor, wires, ignition coil, MAP sensor, air filter , oil and oil filter,
Tires are brand new 31" and I installed new WARN locking hubs. If you opt to put the auto lockers back in I installed a new transfer case motor for an easy transition. New front wheel studs and lug nuts. I also put in a new winshield wiper motor and wipers. Battery and starter are new as well.. Yes, the rear window works. Everything on this truck is stock all the way down to the radio. I have the original owners manual and warranty card. There is ZERO mickey mouse wiring.anywhere in this rig.
What it will need is a new carpet kit or vinyl flooring.
I dont think I'm forgetting anything else.
Seriously inquiries only
No, I dont want help selling
Will entertain project trades up to $3k in value as it sits, not what it would be finished. looking for motorcycles, dirt bikes, muscle cars, things that go pew pew., mid 90's early 2000 snowmobiles
This Bronco will be finished up this weekend and ready to view. Throwing out a picture early. I am the second owner and have gone through this vehicle thoroughly to make it a great daily driver. The original owner passed and this sat for a couple of years before I took possession of it. It has had new quarters patched in and new paint about 6 years ago. It is presentable but wont be in the Pebble Beach Concours d'Elegance anytime soon. The transmission was replaced at 179k in 2018 with a remanufactured one from AAMCO. Yes I have the paperwork. I also went ahead and replaced the shifter cable and MLPS. Now, here is what has been done to it within the last 100 miles.
For the front end and steering I replaced the upper and lower ball joints, new tie rods and drag link, new sway arm bushings and end links, new steering box and pitman arm, new pro comp ES 9000 quad shocks front and back,new pads, rotors, calipers, and abs sensors. Previous owner did the a-arm bushings. After this was done it went to point•S for the alignment and brake fluid flush. I was informed the rear brake cylinder was leaking so I had them do a complete rear brake job with new drums, shoes, cylinders etc.
The cooling system has been replaced with the following New radiator and cap, new hoses, new heater core, new water pump, new thermostat and housing, and fan clutch. While this was out I went and put in a new timing chain and gears as well as timing cover. While the timing cover was out I put in a new harmonic balancer and oil pressure switch. All hardware was replaced with stainless steel bolts aside from the stud kid. It is new, just not stainless.
I removed the throttle body and installed a new gasket, throttle body positioning sensor and idle air control valve.. The tank was drained of the old gas at pointS, new fuel filter and i went and had them do a fuel pressure check and the pump is doing what it needs to do
I gave it a complete tune up with plugs, cap, rotor, wires, ignition coil, MAP sensor, air filter , oil and oil filter,
Tires are brand new 31" and I installed new WARN locking hubs. If you opt to put the auto lockers back in I installed a new transfer case motor for an easy transition. New front wheel studs and lug nuts. I also put in a new winshield wiper motor and wipers. Battery and starter are new as well.. Yes, the rear window works. Everything on this truck is stock all the way down to the radio. I have the original owners manual and warranty card. There is ZERO mickey mouse wiring.anywhere in this rig.
What it will need is a new carpet kit or vinyl flooring.
I dont think I'm forgetting anything else.
Seriously inquiries only
No, I dont want help selling
Will entertain project trades up to $3k in value as it sits, not what it would be finished. looking for motorcycles, dirt bikes, muscle cars, things that go pew pew., mid 90's early 2000 snowmobiles

Specifications

  • Year: 1993  
  • Make: Ford  
  • Model: Bronco  
  • Trim: XLT  
  • Body: SUV  
  • Mileage: 184,000  
  • VIN: 1FMEU15H9PLA60698  
  • Title Type: Clean Title  
  • Exterior Color: White  
  • Interior Color: Gray  
  • Transmission: Automatic  
  • Liters: 5.8L  
  • Cylinders: 8  
  • Fuel Type: Gasoline  
  • Number of Doors: 2  
  • Exterior Condition: Good  
  • Interior Condition: Good  
  • Drive Type: 4-Wheel Drive  
  • Ad Number 6682248
  • Page Views 873 Views
  • Favorite of 11 People
  • Member Since Aug 2010

Report Abuse Form

Please completely fill out the form and re-submit.
Check All That Apply Click on the ? next to each category below for more info
Wrong or Deceptive Price, Wrong Phone # or disconnected. Misleading or confusing item/service description. Ad is being used to send a message rather than sell an item/service.
This ad is not in the appropriate section/subsection of the classifieds.
This ad contains inappropriate images/text which is considered to be offensive. This ad is being used to play a joke on someone.
This same ad/item/service by this seller is found elsewhere in the classifieds.
Cancel

Important Safety Tip

We work hard to protect you and this service from fraud. As with any classifieds service please be aware of the warning signs relative to buying and selling online. Concerned about this ad?

More Ads From This Seller

You may want to drive

    Vin Info Has Changed

    What’s this mean?

    KSL Cars uses VIN info to automatically pull details about vehicles listed on the site. The seller edited some info when they created this listing – the changes they made are marked with this symbol.

    This doesn’t always mean something is wrong – we just think you should know that changes were made. But it’s probably a good idea to ask the seller about them. As always, if you don’t feel comfortable about it, do not proceed with the purchase.

    Click here to get even more info on how to protect yourself.

    Vin Info Has Changed

    What’s this mean?

    KSL Cars uses VIN info to automatically pull details about vehicles listed on the site. The seller edited some info when they created this listing – the changes they made are marked with this symbol.

    This doesn’t always mean something is wrong – we just think you should know that changes were made. But it’s probably a good idea to ask the seller about them. As always, if you don’t feel comfortable about it, do not proceed with the purchase.

    Click here to get even more info on how to protect yourself.

    // TODO: Remove along with statcontroller few month after release of BQ // END TODO